e26f1d14

4.5.3. Removal and installation of components of the GRM drive

This procedure is among those which performance does not demand removal of the engine from the car.

Details of installation of components of the GRM drive

1 — the Damper of tortional fluctuations
2 — the Pulley of a bent shaft
3 — the Right cover of the GRM drive
4 — the Left cover of the GRM drive
5 — the Cover of a head of cylinders
6 — the Tension roller with a spring
7 — the Gas-distributing belt

8 — a TNVD drive Cogwheel
9 — Gear a camshaft drive wheel
10 — the Cogwheel of a bent shaft
11 — the Thermostat
12 — the Basic arm of the fan of the cooling system
13 — the Sealing plate
14 — the Water pump with basic a generator lump


 PERFORMANCE ORDER

  1. Take off a GRM drive belt (see the Section Check of a State and Replacement of a Belt of the GRM Drive in the Head the Current leaving and service).
  1. For the purpose of prevention of risk of input of valves in contact with pistons at removal of cogwheels develop a bent shaft so that the adjusting tag on its cogwheel was displaced under 45 ° relatively risks on the case of the oil pump.
  1. Release a bolt of fastening of a cogwheel of TNVD, - the wheel can be blocked from a provorachivaniye by threading in openings in its spokes of couple of bolts (M8 x 1.25 x 30 ÷ 40) with a vvorachivaniye of their ends in a carving opening in a basic arm of pump assembly.
  1. By means of a special stripper make dismantle of a cogwheel of TNVD.
  1. Uncover a head of cylinders and, holding the camshaft from a provorachivaniye for specially provided lysk, - try not to damage a key casting of a head, - turn out a fixing bolt and, working in a manner similar described in paragraph 4, remove a GRM drive cogwheel.
  1. By means of special adaptation block from turning a flywheel / a driving disk (see an illustration) and remove a cogwheel from a bent shaft.
  2. At installation of components into place track correctness of combination of adjusting tags (see the Section Check of a State and Replacement of a Belt of the GRM Drive in the Head the Current leaving and service). Tighten all fixture with the required effort.