4.5.10. Removal and installation of the oil cooler
Details of installation of the oil cooler
Oil cooler design
|
|
|
|
1 — the Oil filter |
3 — the Cap |
|
PERFORMANCE ORDER |
|||
|
- 1. Introduction
- 2. Governing bodies and methods of operation
- 3. Current leaving and service
- 4. Engine
- 4.1. Check of compression pressure, assessment of a condition of cylinders
- 4.2. Check of the engine by means of the vacuum gage
- 4.3. Belts of the drive of auxiliary units
- 4.4. Petrol models
- 4.5. Diesel models
- 4.5.1. The lubrication system - the general information
- 4.5.2. Removal and installation of the engine
- 4.5.3. Removal and installation of components of the GRM drive
- 4.5.4. Check and adjustment of valvate gaps
- 4.5.5. Removal and installation of the inlet pipeline and final collector
- 4.5.6. Service of a head of cylinders and components of the gas-distributing mechanism
- 4.5.7. Dismantling and assembly of the block of cylinders, service of components
- 4.5.8. Removal and installation of the pallet of a case
- 4.5.9. Removal, installation and service of the oil pump
- 4.5.10. Removal and installation of the oil cooler
- 4.5.11. Removal and installation of a flywheel
- 4.5.12. Removal and installation of masloraspylitel
- 4.5.13. Replacement of epiploons of a bent shaft
- 5. Cooling systems, heating, ventilation and air conditioning
- 6. Power supply systems, engine management / decrease in toxicity of the fulfilled gases and production of the fulfilled gases
- 7. Systems of electric equipment of the engine
- 8. Five-step manual box of gear shifting
- 9. Automatic transmission
- 10. Transmission line
- 11. Brake system
- 12. Suspension bracket and steering
- 13. Body
- 14. Onboard electric equipment
- 15. Control body sizes
- 16. Schemes of electric connections
