e26f1d14

4.4.3. Removal and installation of components of the GRM drive

This procedure is among those which performance does not demand removal of the engine from the car.

Details of installation of components of the GRM drive see also Section Check of a State and Replacement of a Belt of the GRM Drive in the Head the Current leaving and service.

Details of installation of components of the GRM drive

1 — the Pulley of a bent shaft
2 — the Thermostat
3 — the Top cover of the GRM drive
4 — the Lower cover of the GRM drive
5 — the Directing washer

6 — the Tension roller with a spring
7 — the Intermediate roller
8 — the Gas-distributing belt
9 — Cogwheels of the drive of camshafts
10 — the Cogwheel of a bent shaft


 PERFORMANCE ORDER

  1. At an otpuskaniye of bolts of fastening of a pulley and a cogwheel of a bent shaft the last can be blocked from a provorachivaniye by fixing of a gear wreath of a flywheel / a driving disk by means of special adaptation. Try not to damage a damper of tortional fluctuations in a stupichny part of a pulley.
  1. Camshafts can be blocked from a provorachivaniye at an otpuskaniye of bolts of fastening of cogwheels of their drive through windows in a face part of the last.
  1. At installation of components into place track correctness of combination of adjusting tags (see the Section Check of a State and Replacement of a Belt of the GRM Drive in the Head the Current leaving and service). Tighten all fixture with the required effort.