- Disconnect a negative wire from the battery.
|
|
- Turn out two top bolts of a rack of the inlet pipeline.
|
- Hang out the car over zemlny.
- Merge motive oil (see the Head the Current leaving and service), then screw into place and tighten a drain stopper with the required effort, - in case of need replace its sealing washer.
- Prop up the forward bridge assembled with cardan in bulk.
- Turn out three bolts of fastening of a case of the forward bridge and remove the left plug of a support of its suspension bracket.
- Carefully lower the bridge.
|
|
- Turn out fixing bolts and take off intensifying kerchiefs, established on both sides of the engine, - for fastening of each kerchief four bolts are used.
|
- Turn out the corresponding bolts (3 4 pieces) and remove panels of protection of cases of the engine and transmission.
- Turn out 19 bolts of fastening of the pallet of a case of the engine.
- Hooking the thin pallet, or other suitable tool, accurately separate the pallet from a maslootrazhatel, - try not to bend a fixing flange of the pallet and not to damage a maslozaborny tube.
- Turn out four fixing bolts and remove the maslozabornik equipped with the mesh filter, - try not to bend a maslootrazhatel and not to damage a maslozaborny tube.
- Turn out one fixing bolt and remove a maslootrazhatel.
- Carefully clear the interfaced surfaces of the removed components, having completely removed from them traces of oil, dirt and the remains of old sealant.
- Examine the pallet on existence of cracks, deformations and other mechanical damages. In case of need make the corresponding recovery repair, or replace the pallet.
- Estimate a condition of a drain stopper of the pallet, in case of need make its replacement.
|
|
The sealing washer of a drain stopper will be reasonable to be replaced regardless of its state. |
- Check a condition of a maslootrazhatel and the mesh filter of a maslozabornik. Carefully clean components, in case of identification of irreversible damages make replacement.
|
|
