e26f1d14

14.6. Assembly blocks of safety locks / relay - the general information, removal, installation, replacement of safety locks

General information

All onboard electrical wiring used on the considered models can be broken into 13 main plaits conditionally:

  1. Front electrical wiring plait
  2. Plait of an electrical wiring of a combination of devices
  3. Dashboard electrical wiring plait
  4. Plait of an electrical wiring of fuel injectors / nozzles
  5. Engine electrical wiring plait
  6. Plait of an electrical wiring of salon
  7. Back electrical wiring plait
  8. Plait of an electrical wiring of a rear bumper
  9. Plait of an electrical wiring of the left forward door
  10. Plait of an electrical wiring of the right forward door
  11. Plait of an electrical wiring of the left back door
  12. Plait of an electrical wiring of the right back door
  13. Back door electrical wiring plait

For protection of onboard consumers of the electric power the safety locks placed in two assembly blocks, one of which - main - is located in the right part of a motive compartment, are used, the second is built in in the dashboard to the left of a steering column and equipped with a folding cover.

Replacement of safety locks

Schemes of an arrangement of safety locks in assembly are provided in Specifications of the Head Onboard electric equipment at the beginning of the present chapter. The label with the scheme of an arrangement of internal components is usually pasted also on a removable cover of the main assembly block.

 PERFORMANCE ORDER

  1. For replacement of the failed safety lock which is located in the saloon assembly block open the plastic cover equipped with loops with the inscription "FUSE" in the basis of a forward rack under the dashboard at the left, then by means of the clip fixed in the block take a defective safety lock, - and establish on its place replaceable, calculated on the same current.
  1. Replacement of safety locks of the main assembly block is made in a similar manner, - try not to drop a removable cover in a motive compartment.

Removal and installation of the main assembly block

 PERFORMANCE ORDER

  1. Disconnect a negative wire from the battery.
  1. Release a fixing nut.
  1. Previously having marked, disconnect an electrical wiring and take the assembly block from a motive compartment.
  2. Installation is made upside-down.