e26f1d14

11.8. Removal and installation of assembly of the vacuum amplifier of brakes

At removal act as numbering of components.

Order of dismantle of assembly of the vacuum amplifier of brakes

1 — Sockets of an electrical wiring of the sensor switch of level of brake fluid and the differential sensor switch
2 — the Vacuum hose
3 — Brake lines
4 — the Bolt
5 — the Valve regulator
6, 9 — Nuts

7 — the Basic arm of the valve regulator
8 — GTTS
10 — the Clamp
11 — the Finger
12 — the Vacuum amplifier
13 — Sealing laying


 PERFORMANCE ORDER

  1. Remove GTTs (see the Section Removal, service and installation of the main brake cylinder).
  2. Disconnect a vacuum hose from assembly of the brake amplifier.
  1. In interior of the car remove a clamp and take a finger of fastening of a rod of a pusher to a brake pedal.
  1. From the back party of a partition of a motive compartment release four fixing nuts and remove assembly of the vacuum amplifier with GTTs pusher.
  1. Installation is made upside-down, - track observance of requirements of Specifications of the Head the Brake system to efforts of tightening of carving fixture. Do not forget to adjust pusher rod length (see the Section Removal, service and installation of the main brake cylinder) and to pump over a hydraulic path (see the Section Pumping of Brakes)