e26f1d14

13.2.5. Removal and installation of bumpers

Front bumper

Details of installation of a front bumper

1 — the Front grille
2 — Side basic arms
3 — the Facing panel
4 — the Polymeric absorber of shock loadings

5 — the Amplifier
6 — the Basic arm
7 — the Shock arm
8 — the Insulator
9 — the Frame


 PERFORMANCE ORDER

  1. Remove a mud-chipper from a bumper.
  2. Turn out two (left and right) top side a bolt of fastening of a bumper.
FRT — Forward
  1. Remove side basic arms of fastening of a bumper.
  1. Give four adjusting waste nuts.
  1. Carefully remove a bumper from the car, - it will be reasonable to use the help of the assistant.
  2. Release sixteen clamps of fastening of the facing panel and the amplifier of a bumper. Divide a bumper into three sections (facing, a polymeric damper and the amplifier).
  3. Visually estimate a condition of the facing panel and a polymeric damper of absorption of shock loadings. Replace defective components.
  4. Installation is made upside-down, track observance of requirements of Specifications of the Head Kuzov to efforts of tightening of carving fixture.

Rear bumper

Details of installation of a rear bumper (1 of 2)

1 — Side basic arms
2 — the Facing panel
3 — the Polymeric absorber of shock loadings

4 — the Amplifier
5 — Slips
6 — Lamps of illumination of registration plate
7 — the Basic arm


Details of installation of a rear bumper (2 of 2).

 PERFORMANCE ORDER

  1. Turn out two fixing bolts and remove a mud-chipper from a bumper.
  2. Give four (on two from each party) adjusting waste nuts from below under a bumper.
  3. Disconnect an electrical wiring of fires of illumination of registration plate and fires of a backing.
  4. Remove a bumper.
  5. Release seventeen clamps of fastening of the facing panel and the amplifier of a bumper. Divide a bumper into three sections (facing, a polymeric damper and the amplifier).
  6. Visually estimate a condition of the facing panel and a polymeric damper of absorption of shock loadings. Replace defective components.
  7. Installation is made upside-down, track observance of requirements of Specifications of the Head Kuzov to efforts of tightening of carving fixture.