e26f1d14

12.3.6. Removal, service and installation of the lower levers of a suspension bracket

Removal

All models

 PERFORMANCE ORDER

  1. Hang out the car above the ground.
  2. Remove forward wheels.
  3. Remove the stabilizer of cross stability (see the Section of System of electric equipment of the engine).
  4. Release a fixing nut and take an axial bolt of fastening to the lower lever of a basic fork of rack-mount assembly (see the Section Removal, service and installation of rack-mount assemblies).
  5. Disconnect from a rotary fist a tip of steering draft (see the Part Steering).
  6. Release a coupling bolt and release from a rotary fist a finger of a spherical support of the top lever of a suspension bracket (see the Section Removal, service and installation of the top levers of a suspension bracket).

Model 4 x 4

 PERFORMANCE ORDER

  1. Turn out bolts (2) fastenings of the lower spherical support to lever assembly (1).
  1. Remove a rotary fist assembled with a power shaft (see the Head the Transmission line).
  1. Take the forelock, release a koronchaty nut and by means of a special stripper release a spherical support (1) from a rotary fist.

Model 4 x 2

 PERFORMANCE ORDER

  1. Take the forelock, release a koronchaty nut and by means of a stripper release a spherical support from assembly of a rotary fist, - in case of need the spherical support can be dismantled from lever assembly after removal of the last from the car.

  1. The spherical support is fixed in a rotary fist by means of a koronchaty nut (1) (model 4 x 2).
  1. Vypressovyvany the lower spherical support from a rotary fist (model 4 x 2).

All models

 PERFORMANCE ORDER

  1. Release nuts of shpindelny bolts (2), take the last and remove lever assembly (1) from the car.

Service

 PERFORMANCE ORDER

  1. Examine on existence of deformations, cracks and other mechanical damages the lower lever of a suspension bracket and an axial finger of fastening to it a basic fork of rack-mount assembly. Estimate a condition of rubber shpindelny plugs and a boot of a spherical support and a spherical tip of a head of an axial bolt. Replace defective components.
  1. Vypressovyvany and zapressovyvany rubber shpindelny plugs it is made by means of special adaptation, - before installation the new plug should be moistened with soap solution.
  1. The support spherical in case of need is replaced assembled, as well as an axial finger of fastening of the basic plug of rack-mount assembly.

Installation

 PERFORMANCE ORDER

  1. Installation is made upside-down, - track observance of requirements of Specifications of the Head Podvesk and steering to efforts of tightening of carving fixture.