e26f1d14

6.2.15. Removal and installation of the toplivoraspredelitelny highway

See the prevention at the beginning of the Section Removal and installation of the fuel pump!

See also materials of the Section Removal and installation of components of an inlet air path.

Details of installation of the toplivoraspredelitelny highway

1 — Negative hollow batteries
2 — the Electrical wiring of connection of injectors with contact sockets
3 — the fuel pressure Regulator
4 — the Fuel hose

5 — the highway Toplivoraspredelitelnaya
6 — the Lock ring
7 — the Injector
8 — the Sealing ring
9 — the Damper of pulsations of pressure


 PERFORMANCE ORDER

  1. Dump pressure in a power supply system (see the Section Dropping Pressure in fuel system of the petrol engine, filling of a fuel path).
  2. Merge cooling liquid (see the Head the Current leaving and service).
  3. Disconnect a negative wire from the battery.
  4. Turn out two bolts of an air duct of an inlet air path.
  5. Release a collar of fastening of hose section of an air duct to inlet section of the case of a throttle.
  6. Remove four ventilating hoses connected in an air duct.
  7. Disconnect an electrical wiring from the MAF sensor.
  8. Turn out bolts of fastening of assembly of the MAF sensor.
  9. Release a collar of fastening of an air duct to assembly of the air cleaner.
  10. Turn out a bolt of fastening of a basic arm of an air duct.
  11. Turn out bolts of fastening of a basic arm of a cable of the drive of butterfly valves.
  12. Disconnect a cable of the drive of butterfly valves.
  13. Remove the vacuum hose going from the inlet pipeline to a vacuum tube.
  14. Disconnect an electrical wiring from TPS and the IAC valve.
  15. Disconnect two hoses of a cooling path from the throttle case.
  16. Release a fixing collar and disconnect a hose of assembly of the IAC valve.
  17. Release a collar and disconnect a hose from the air distributor.
  18. Release collars and disconnect vacuum hoses of the brake amplifier and a tempostat from the air distributor.
  19. Turn out two fixing bolts and remove the air distributor a basic arm.
  20. Turn out the lower bolt of a basic arm of the IAC valve.
  21. Turn out two top bolts of a basic arm of the inlet pipeline.
  22. Hang out the car above the ground.
  23. Turn out the lower bolts of a basic arm of the inlet pipeline.
  24. Lower the car on the earth.
  25. Disconnect an inlet hose of a heater from a knee.
  26. Disconnect a vacuum hose from a vacuum tube.
  27. Give three bolts with nuts and remove the air distributor.
  28. Disconnect a fuel-supply line from pressure regulator.
  29. Disconnect the giving hose from the toplivoraspredelitelny highway.
  30. Turn out two bolts of fastening of the highway.
  31. Remove clamps of fastening of injectors and remove the toplivoraspredelitelny highway.
  32. Remove two injector insulators (see the Section Removal and installation of fuel injectors).
  33. Remove a damper of pulsations of pressure.
  34. Remove the fuel pressure regulator (see the Section Removal and installation of the regulator of pressure of fuel).
  35. Carefully smooth out all interfaced surfaces.
  36. Installation is made upside-down. Do not forget to adjust a cable of the drive of a butterfly valve (see the Section Removal and installation of the accelerator pedal, adjustment of a cable of the drive of a butterfly valve).
  37. In conclusion fill the cooling system, start the engine and check it for existence of signs of leak of the corresponding working liquids.