e26f1d14

5.3.7. Removal, check and installation of the fan of the K/V condenser

Removal

 PERFORMANCE ORDER

  1. Ventilatory assembly is located ahead of the condenser heat exchanger, behind a forward lattice at once.
  2. Prop up wheels antiretractable boots.
  3. Disconnect a negative wire from the battery.
  4. Remove three clamps of fastening of the finishing panel to the top section of a forward casing.
  5. Turn out the screw of fastening of a forward lattice to a cowl rack.
  6. Accurately wring out four lock uvulas and remove a forward lattice.
  7. Release clamps from side sections of a forward casing and latch them on the regular places in a forward lattice.
  1. Disunite the condenser fan electrical wiring socket.
  1. Turn out fixing bolts and remove ventilatory assembly.

Check

 PERFORMANCE ORDER

  1. By means of an ohmmeter make sure available conductivity between fan electrical wiring socket plugs. If conductivity is absent, replace a driving electric motor.
  2. Give food of 12 V on electric motor plugs, - if the krylchatka does not begin to rotate, replace an electric motor.

Installation

 PERFORMANCE ORDER

  1. Installation is made as it should be, the return to an order of dismantle of components, - track observance of requirements of Specifications of the Cooling system, heating, ventilation and air conditioning to efforts of tightening of carving fixture and reliability of a zashchelkivaniye of clamps.