5.3.6. Removal, check and installation of the K/V compressor



  1. Disconnect a negative wire from the battery.
  2. By forces of the trained professional make a discharge of a refrigerator path of the К/В system.
  3. Disconnect from the compressor refrigerator lines, - at once to a zakuporta the open ends of nipple sockets in order to avoid internal pollution of the working highway K/V.
  1. Disunite the compressor clutch coupling electrical wiring socket.
  1. The car also establish to Poddomkratta it on props.
  2. Remove protection of a case of the engine.
  1. Weaken a nut of a pulley of a natyazhitel of a belt of the drive of the К/В compressor.
  1. By rotation of an adjusting bolt in the direction counterclockwise release a belt, throw off it from pulleys and remove.
  2. Lower the car on the earth.
  1. Turn out four fixing bolts (1) and remove the compressor.



  1. Aurally make sure of serviceability of operation of a magnetic clutch coupling of the compressor when giving on its plugs of food in 12 Century.
  1. Check the coupling and its driving pulley for existence of potek of oil, deformations and other mechanical damages. Replace defective components.
  1. By selection of an adjusting washer of the corresponding thickness adjust gap size between the faceplate and a pulley of a rotor. The required value makes 0.35 ÷ of 0.65 mm.



  1. Installation is made as it should be, the return to an order of dismantle of components, - track observance of requirements of Specifications of the Head of the Cooling system, heating, ventilation and air conditioning to efforts of tightening of carving fixture.
  2. In conclusion by forces of the trained professional make evacuation, vacuum check and charging of a refrigerator path of the K/V system, then start the engine, activate To/in and examine nipple sockets of a refrigerator path on existence of signs of development of leaks. In case of need make the corresponding corrections.