e26f1d14

10.2.4. Removal and installation of a pedal of coupling

Details of installation of a pedal of coupling

1, 4, 11 — Nuts
2, 6 — Bolts
3 — the Returnable spring
4 — the Flat washer
7 — the Remote plug
8 — Axial plugs
9 — the Clamp (is subject to replacement without fail)

10 — the Finger
12 — the Pusher
13 — the Cutting head
14 — the Emphasis
15 — the Pedal
16 — the Overlay of a block


 PERFORMANCE ORDER

  1. Take a clamp and a finger of fastening of a pusher.
  2. Disconnect a returnable spring.
  3. Give a fixing nut, remove a washer and take an axial bolt.
  4. Take remote and two axial plugs.
  5. Estimate degree of wear of axial plugs and an overlay of a block whether check the lever of a pedal is bent and whether the returnable spring weakened. Replace defective components.
  6. Installation is made as it should be, the return to an order of dismantle of components, - axial and remote grease plugs before landing with lithium lubricant (NGLI No. 2). Track observance of requirements of Specifications of the Head the Transmission line to efforts of tightening of carving fixture.
  7. In conclusion do not forget to adjust a free wheeling of a pedal (see the Section Check and adjustment of a pedal of coupling).