e26f1d14

9.7. Removal and installation of the lever of the AT selector

Design and details of installation of the lever of the AT selector

1 — the Handle
2 — the Casing
3 — the Display panel

4 — the Shpindelny bolt
5 — the Directing plate
6 — the Lever


 PERFORMANCE ORDER

  1. Disconnect a negative wire from the battery.
  2. Remove back and forward sections of a console ware box (see the Head Kuzov).
  1. Transfer the AT selector lever to situation "P", then release fixing nuts.
  1. Take the forelock and separate from the lever (1) a selector rod (2).
  1. Disconnect an electrical wiring of the indicator of provisions and the switch of the HOLD mode.
  2. Turn out the fixing screw and remove the handle and a casing from the lever.
1 — the Handle
2 — the Casing
  1. Remove the display panel (1).
  1. Release a fixing nut, take a shpindelny bolt (1) and separate the lever from the directing plate.
  1. Grease the specified elements of the directing plate.
  1. Grease the expansion plug, fill the lever on the regular place in the directing plate and record it a shpindelny bolt, having tightened a nut of the last with the required effort (11.7 ÷ 16.7 Nanometers).
  1. Further installation is made as it should be, the return to an order of dismantle of components, - the effort of tightening of the screw of fastening of the handle of the lever makes 2.0 ÷ 3.0 Nanometers, nuts of the directing plate of lever assembly, - 17.6 ÷ 26.5 Nanometers. Do not forget to restore initial connection of an electrical wiring.