e26f1d14

7.3.7. Removal and installation of a starter

Petrol models

Removal

 PERFORMANCE ORDER

  1. Disconnect a negative wire from the battery.
  2. Turn out two top bolts of fastening of a basic arm of the inlet pipeline.
  3. Hang out the car above the ground.
  1. On models with RKPP turn out two fixing bolts and take aside the executive cylinder of coupling.
  1. Turn out two lower fixing bolts and remove a basic arm of the inlet pipeline.
  1. Turn out two top bolts of fastening of a starter.
  1. Turn out the lower fixing bolt, release a starter from a coupling dome (model with RKPP) / the hydrotransformer (model with AT) and, having propped up, record it in a motive compartment.
  2. Lower the car on the earth.
  3. From above disconnect an electrical wiring from the starter plug S.
  1. Release a fixing nut and disconnect an electrical wiring from the starter B (1) plug, - do not drop a lock washer.
  1. Again lift the car, take aside a braid of an electrical wiring of transmission and through a bottom take a starter from a motive compartment.

Installation

 PERFORMANCE ORDER

  1. Bring a starter to a motive compartment.
  2. Lower the car on the earth and connect an electrical wiring to the starter plug B, - do not forget to put a lock washer, track reliability of tightening of a nut.
  3. Connect an electrical wiring to the plug S.
  1. Get a basic arm of the inlet pipeline on the regular place and record it two top bolts.
  1. Lift the car and get a starter on the regular place.
  2. Screw at first two top fixing bolts, then lower.
  3. Level a starter, then tighten three fixing bolts with the required effort (37 ÷ 54 Nanometers).
  4. Screw and tighten the lower bolts of fastening of a basic arm of the inlet pipeline with the required effort (37 ÷ 54 Nanometers).
  5. On models with RKPP install into place the executive cylinder of coupling, - the effort of tightening of fixing bolts also makes 37 ÷ 54 Nanometers.
  6. Lower the car on the earth and tighten the top bolts of a basic arm of the inlet pipeline with the required effort (37 ÷ 54 Nanometers).

Diesel models

Details of installation of a starter on diesel models

 PERFORMANCE ORDER

  1. Disconnect a negative wire from the battery.
  2. Turn out the top bolts of fastening of a starter.
  3. Hang out the car above the ground.
  4. Disconnect an electrical wiring from starter plugs B and S, - try not to lose a lock washer at an otpuskaniye of a fixing nut of the plug B.
  5. Turn out the lower fixing bolts and remove a starter.
  6. Installation is made upside-down, - track observance of requirements of Specifications of the Head Sistema of electric equipment of the engine to efforts of tightening of carving fixture.