e26f1d14

8.3. Removal and RKPP installation

 PERFORMANCE ORDER

  1. Disconnect a negative wire from the battery.
  2. Hang out the car above the ground.
  3. Merge gearbox oil (see the Head the Current leaving and service).
  1. Disconnect back and forward (at the corresponding complete set) driveshafts, - do not forget to mark previously the provision of a shaft concerning the connecting flange.
  1. Disconnect an electrical wiring from the sensor switch of fires of a backing.
  1. At the corresponding complete set disconnect the socket of the sensor switch of activation of the all-wheel drive mode on the transfer case.
  1. Disconnect an electrical wiring from the sensor of the speed (VSS).
  1. Turn out bolts of fastening of transmission assembly to the engine and take off a rastyazhny kerchief.
  1. Disconnect an electrical wiring from the sensor of provision of a bent shaft (CKP).
  1. Remove a starter (see the Head Sistemy of electric equipment of the engine), a basic arm of system of production of the fulfilled gases (see Power supply systems, managements of engine/decrease in toxicity of the fulfilled gases and production of the fulfilled gases) and a rastyazhny kerchief.
  2. Turn out a fixing bolt and remove a basic arm of fixing of a hose of a hydraulic actuator of coupling, then give bolts and dismantle the executive cylinder.
And — Petrol models
In — Diesel models
  1. Remove the lever of switching of RKPP (see the Section Removal and installation of the lever of switching of RKPP).
  2. At the corresponding complete set remove the lever of switching of the transfer case (see the Head the Transmission line).
  1. Prop up a basic beam of transmission assembly by a cart jack.
  1. Turn out bolts of fastening of a beam and lower the last on a jack together with transmission assembly.
  1. Turn out a bolt of fastening of a rubber pillow of a support of a suspension bracket of transmission assembly.
  2. At the corresponding complete set turn out fixing bolts and separate the transfer case from RKPP.
  3. Installation is made upside-down, - track observance of requirements of Specifications of the Head the Five-step manual box of gear shifting to efforts of tightening of carving fixture.

Before connection of the transfer case grease its interfaced surface with sealant. At connection of driveshafts track correctness of combination of the landing tags put in the course of dismantle.